Blades are cheap too 12 for a 2 pack carbide set. That is enough for 26 inch wood pieces.
Can A 10 Inch Miter Saw Cut A 4×4 Perfect Cuts And Miters
How Wide Cuts You Can Make With 10 Inch Miter Saw
Delta 10 Inch Power Miter Saw 2×6 4×4 Single Pass Cutting
They dont make 8 circular wood cutting saws so forget about trying to find one of those.
Can a 10 inch miter saw cut a 4×4. Also when cutting at an angle some of the widths of the blade is lost. If you do find that you have to cut a piece that is larger than six inches and all you have is a 10 inch miter saw you do have a couple of options. But yes cutting a 4×4 can be done using a 7 14 saw a speed square and a pencil to make marks on all four sides then slowly cut on the line.
Measure the washer that holds the blade on. Even if it is smaller than 1 the motor housing may hit the 4×4 stopping the blade from vutting any deeper. The 10 inch saw can also cut a piece of two by four lumber at a 450 angle.
By using the stationary miter saw with 10 inch blade you wont be able to cut a 44 in one swing. A miter saw that uses a 10 inch blade can deliver right angle cuts off a board that is 55 wide which should be sufficient for a piece of two by six lumber. If you have a 10 inch miter saw you should assume that a 4×4 is the biggest piece that you will be able to cut.
You can however cut as far as the saw will go down then roll the 4×4 over to finish. While a 10 inch blade on a miter saw can cut through a 4×4 in one or two steps this may not be enough from a practical standpoint. That is why a wood measuring between 24 inches and 28 inches is what it can typically handle.
10 will cut through a 4×4 but it wont cut all the way thru a 2×6 at a 45 degree angle. If you want to get the job done faster and smoother you should definitely consider either a 12 inch miter saw of any type or a 10 inch sliding miter saw. When it comes to talking about the cutting capacity of the 10 inch miter saw it will cut the 44 woodbut to do so it will pass some hard time.
Maybe they did when your dad was young but not these days. A 10 inch saw can cut lumber or plywood up to 125 inch thick without causing disturbance to users. Upfront bevel lock lever and range selector knob easily accessed cont.
But a miter saw makes for a nice clean cut though. If it is more than 1 in diameter you cant cut a 4×4 in one cut. Well this makes me feel a little better about getting a 10 skil miter saw but this thing cuts just fine and anything too big for a single cut i can turn around do a blade check and cut again.
The typical 10 inch miter saw can cut a width of 55 inches. If you do any framing or deck building get the 12.
Compound Miter Saw Buying Guide
Best Miter Saw For The Money Buying Guide Chainsaw Journal
Useful Makita Ls1040 Review Can You Make Splinter Free Cuts 2019